WC type low pressure Venturi dust collector

Introduction of WC type low pressure Venturi Dust Collector:

The WC type low pressure Venturi dust collector is a kind of high efficiency wet dust collector, which is studied and designed by the Beijing non-ferrous Metallurgical Design and Research Institute, which is based on foreign equipment and related materials. After several years of application practice, it is proved that the equipment can be widely applied to occasions where dust removal efficiency is high and can also be used for washing and purifying harmful gases.

Structure and principle of WC type low pressure Venturi dust collector:

The principle is that the dusty gas in the Scriptures is exposed to the water flowing down the water wall of the Venturi tube. The water droplets are spatter at the throat of the throat, resulting in the formation of fine water droplets. The dust is caught by the water droplets by the collision with the water droplets, or directly into the water surface of the sedimentation tank because of the aggregation of the water or the agglomeration of the larger dust particles. Less particles are trapped by the gas again in the cyclone. The cyclone is dehydrated at the same time.

WC type low pressure Venturi dust collector operation:

1. Due to water removal, the operation should be antifreeze.

2. Adjust the valve on the water supply pipe and use the water hole to send out 2cm high water column.

3. Adjust the opening degree of the valve at the bottom of the dust collector, so that there is a small amount of water overflow in the overflow pipe during operation.

4. It is water saving and can be recycled.

WC type low pressure Venturi dust collector used:

The dust collector has been identified and identified as follows: "reasonable design, advanced performance, qualified quality and good user response".

The equipment has been tested by artificial dust removal in the manufacturing plant. The Beijing Institute of non-ferrous metallurgy design and research and the Anshan Iron and Steel Institute of labor and hygiene have carried out the test. The efficiency of dust removal is 98-99.88%.

The dust removal efficiency of a copper mine and basic ceramics was measured. The dust removal efficiencies were 99.17% and 99.99% respectively.

At present, this kind of dust collector is widely used in ore dressing plant, ceramic factory, printing and dyeing plant, copper mine, lead zinc mine, pit crater, high frequency porcelain parts factory, gold mine, foundry workshop, cremation plant, and boiler dust removal.

WC type low pressure Venturi dust collector features:

1. The equipment is actually two stage dust removal, and the efficiency is up to 99%.

2, the resistance of the dust collector is 127mmH2O, and the power consumption is less.

3. The highest concentration of dust in the entrance can reach 35g/m3, and the adaptability is strong.

4. The components are standardized and the cost is low.

5, due to the formation of a water film in the Venturi tube, the wear is small and the service life is long.

6, tight hole, easy to open. As long as the hole is opened, all parts inside the equipment can be touched to facilitate cleaning.

7, the outlet diameter is large, and the water quality requirements are very low, and no blockage is required.

8, water pressure of water supply is more than 0.1kg/cm2.

9, small footprint, easy installation, reliable operation, almost no maintenance, no vulnerable parts.

10, the outlet gas has no water phenomenon.

Contact us if you need more details on Low Pressure Venturi Dust Collector. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Dust Collector with High Quality、WC Type Dust Collector. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Desulphurization Deduster